Panasonic TH42PX20U 50" Hdtv Plasma Display - Page 18
PC INPUT TERMINALS CONNECTION, Notes, Signal Names for D-sub 15P Connector
View all Panasonic TH42PX20U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Cable Connection PC Input Terminals connection COMPUTER S-VIDEO VIDEO L AUDIO R PC INPUT 3 Ferrite core (small size) (supplied) Audio Less than 4" (10 cm) Stereo plug Connect a cable which matches the audio output terminal on the computer. Conversion adapter (if necessary) Less than 4" (10 cm) Less than 4" (10 cm) RGB PC cable Ferrite core (large size) (supplied) D-sub 15p Notes: (1) Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.) (2) The display resolution is a maximum of 768 × 768 dots (TH-42PX20), 1,024 × 768 dots (TH-50PX20) when the aspect mode is set to "4:3", and 1,024 × 768 dots (TH-42PX20), 1,366 × 768 dots (TH-50PX20) when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity. (3) Some PC models cannot be connected to the set. (4) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal. (5) The computer shown in the illustration is for example purposes only. (6) Additional equipment and cables shown are not supplied with this set. (7) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency range. Signal Names for D-sub 15P Connector 11 12 13 14 15 6 7 8 9 10 12345 Pin Layout for PC Input Terminal Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name 1 R 6 GND (Ground) 11 NC (not connected) 2 G 7 GND (Ground) 12 NC 3 B 8 GND (Ground) 13 HD/SYNC 4 NC (not connected) 9 NC (not connected) 14 VD 5 GND (Ground) 10 GND (Ground) 15 NC 18