Panasonic TY-TP50P10S Operating Instructions - Page 9
Mounting Touch Panel
UPC - 037988159321
View all Panasonic TY-TP50P10S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation & Setup Mounting Touch Panel (in Horizontal Posture) 1 Attach mounting brackets to the touch panel. ㊍ Fit the protrusion located above the round hole on mounting bracket A into the hole of the top unit and then tighten mounting screw A by hand. ㊎ As shown in the diagram, tighten mounting screw A by hand to hold mounting bracket B temporarily after fitting the protrusion located above the round hole on the mounting bracket B into the hole of the bottom unit. Screw mounting screw A into the hole of the bottom unit half way. ㊍ Protrusions Mounting screws A Screw Mounting bracket A ㊎ Screw in halfway Protrusion Mounting screws A Screw Mounting bracket B 2 Attach the touch panel to the front of the plasma display. Notes on Assembly • Work in two or more to attach the touch panel to the plasma display. If the touch panel is dropped, injuries may occur. • Because it can damage the infrared sensor of the touch panel, do not lay the touch panel down and attach the plasma display to it from above. Service for damage caused by installation in this way is subject to billing. INCORRECT Plasma display Touch panel Floor 9