Panasonic WJ-GXE100 Installation Guide - Page 13

Screw tightening • The screws and bolts must be tightened with an appropriate tightening torque according to the material and strength of the installation area. • Do not use an impact driver. Use of an impact driver may damage the screws or cause tightening excessively. • Tighten screws at a right angle to the surface. After tightening screws, perform visual check to ensure that the tightening is sufficient enough so that there is no movement or looseness. Radio disturbance When this product is used near TV/radio antenna, strong electric field or magnetic field (near a motor, a transformer or a power line), images may be distorted and noise sound may be produced. PoE (Power over Ethernet) Use a PoE hub/device that is compliant with IEEE802.3af standard. Router When connecting this product to the Internet, use a broadband router with the port forwarding function (NAT, IP masquerade). Refer to the Operating Instructions on the provided CD-ROM for further information about the port forwarding function. For BNC coaxial cable connection Use only the recommended plug below when connecting a BNC coaxial cable (locally procured) to the video input connector on the unit. Applicable plug: MBILN-CC3co9a0x1ia2lCcaobrleM(IloLc-Cal3ly9p0r1o2cu/1re6dF) * Suffixes attached to the standards may be updated. BNC coaxial cable (locally procured) Plug Plug ø1.32 mm - ø1.37 mm ø1.32 mm - ø1.37 mm ø0.13 mm - ø0.69 mm IMPORTANT: • Use a compatible plug. Failure to observe thøi0s.1m3 amymc-aøu0s.e69tmromuble such as poor contact. At worst, the connector of this product may be damaged. Time & date setting It is necessary to set the time & date before putting this product into operation. Refer to the Operating Instructions on the provided CD-ROM for descriptions of how to perform the settings. 13