Panasonic WJ-GXE500 Installation Guide - Page 12

Precautions for Installation Installation work shall be performed in accordance with the technology standard of the electric installation. This product is designed to be used indoors. This product is not operable outdoors. Do not expose this product to direct sunlight for hours and do not install the product near a heater or an air conditioner. Otherwise, it may cause deformation, discoloration and malfunction. Keep this product away from water and moisture. Be sure to remove this product if it is not in use. Radio disturbance When this product is used near TV/radio antenna, strong electric field or magnetic field (near a motor, a transformer or a power line), images may be distorted and noise sound may be produced. Installation place • Place the unit correctly on a level surface. • Do not place the unit in the following places: • Locations where it may get wet from rain or water splash • Locations where a chemical agent is used such as a swimming pool • Locations subject to humidity, dust, steam and oil smoke • Locations in a specific environment where a solvent or a flammable atmosphere exists • Locations where a radiation, an X-ray, a strong radio wave or a strong magnetic field is generated • Locations where corrosive gas is produced, Locations where it may be damaged by briny air such as seashores • Locations where the temperature is not within -10 °C to +50 °C {22 °F to 122 °F}. • Locations subject to vibrations (This product is not designed for on-vehicle use.) • Locations subject to condensation as the result of severe changes in temperature PoE (Power over Ethernet) Use a PoE hub/device that is compliant with IEEE802.3af standard. Router When connecting this product to the Internet, use a broadband router with the port forwarding function (NAT, IP masquerade). Refer to the Operating Instructions (PDF) for further information about the port forwarding function. SIGNAL GND terminal Connect this terminal with the SIGNAL GND terminals of the devices in the system for signal ground. When operating this unit and the devices in the system without signal ground, oscillation or noise may be produced. Heat dissipation To prevent this product from overheating, heed the following. Failure to observe this may cause fire or trouble. • Do not block the ventilation openings. Maintain the unit periodically to prevent dust from blocking openings. 12