Panasonic WJ-GXE500 Installation Guide - Page 26

Dns To Auto.

Get Panasonic WJ-GXE500 PDF manuals and user guides View all Panasonic WJ-GXE500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

z Start the Panasonic IP setting software. x Click the [IP setting] button after selecting the MAC address/IP address of the unit to be configured. Note: • When using a DHCP server, the IP address assigned to the unit can be displayed by clicking the [Refresh] button of the IP setting software. • When a duplicate IP address is used, the corresponding MAC address/IP address will be displayed shaded. c Complete each network setup item and click the [Apply] button. Note: • When using a DHCP server, it is possible to set "DNS" to "AUTO". Important: • It may take for around 2 minutes to complete to upload the settings to the unit after clicking the [Apply] button. The settings may be invalidated when the 12 V DC power supply is cut or when the AC adaptor or the LAN cable is disconnected before completing the upload. In this case, perform the settings again. • When using a firewall (including software), allow access to all UDP ports. 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
26
z
Start the Panasonic IP setting software.
x
Click the [IP setting] button after selecting the
MAC address/IP address of the unit to be con-
figured.
Note:
• When using a DHCP server, the IP address
assigned to the unit can be displayed by click-
ing the [Refresh] button of the IP setting soft-
ware.
• When a duplicate IP address is used, the corre
-
sponding MAC address/IP address will be dis-
played shaded.
c
Complete each network setup item and click
the [Apply] button.
Note:
• When using a DHCP server, it is possible to set
"DNS" to "AUTO".
Important:
• It may take for around 2 minutes to complete to upload the settings to the unit after clicking the
[Apply] button. The settings may be invalidated when the 12 V DC power supply is cut or when
the AC adaptor or the LAN cable is disconnected before completing the upload. In this case,
perform the settings again.
• When using a firewall (including software), allow access to all UDP ports.