Panasonic WJ-NV300 Operating Instructions - Page 57
Con the Panasonic alarm protocol settings [Panasonic alarm protocol], Port numberto PC], Default - software
View all Panasonic WJ-NV300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Configure the Panasonic alarm protocol settings [Panasonic alarm protocol] The settings to notify the PC of the event and error information when an event or an error occurs can be configured on this tab. To display the event and error information, it is necessary that the software (option) is installed on the recipient PC. Refer to the "readme.txt" on the provided CD-ROM for details on the software. [Port number(to PC)] Enter the port number of the recipient PCs. It is usually not necessary change the default. Default: 1818 [Retry] Set the number of retry attempts for the transmission to the PC. 0 - 8 (times) (In steps of times) Default: 2 Note: • If the transmission to the PC fails, increase the number of retry attempts. [Destination address - Address1 - Address8] Enter the addresses of the recipient PCs. Enter the IP address or host name for "Address1" - "Address8". The host name is available only when "Manual" is selected for "DNS" on the [Basic] tab accessed from the "Advanced setup" menu - the "Network" page of the setup menu. Up to 8 destination addresses can be registered. Enter up to 255 alphanumeric characters including hyphens (-) and periods (.). 57