Panasonic WV-LC1700 Operating Instructions - Page 13
Camera Connection, Connection with Two or More, Video Monitors, Digital Disk Recorder, Connection,
View all Panasonic WV-LC1700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Camera Connection Connect the video output connector of camera to the VIDEO IN connector with a coaxial cable. Note: Make sure that the cable length between the camera and monitor is as follows. Cable type RG-59/U 3C-2V RG-6/U 5C-2V RG-11/U 7C-2V RG-11/U 10C-2V Cable length 250 m {820 ft.} 500 m {1 640 ft.} 600 m {1 968 ft.} 800 m {2 625 ft.} To Output Audio Signal Connect the AUDIO IN connector of this monitor to the audio output connector of digital disk recorder (or other recording devices) with an audio cable. PC Connection Connect the PC IN connector of this monitor to the analog RGB output connector of PC (or another device). Check the room around the PC IN connector at the rear and procure a suitable 15-pin Mini D-sub connector cable before the cable connection. Connection with Two or More Video Monitors • Connect the VIDEO OUT connector of this monitor to the video input connector of another monitor with a coaxial cable. • Connect the AUDIO OUT connector of this monitor to the audio input connector of another monitor with an audio cable. Notes: • Up to 10 monitors can be connected to this monitor. If 11 or more monitors are connected, picture quality may be degraded. • Total length of each cable should not exceed 150 m {492 ft.}. Digital Disk Recorder Connection To Perform Recording • Connect the VIDEO OUT connector of this monitor to the video input connector of digital disk recorder (or other recording devices) with a coaxial cable. • If necessary, connect the AUDIO OUT connector of the monitor to the audio input connector of digital disk recorder (or other recording devices) with an audio cable. To Perform Playback Do either of the following. • Connect the VIDEO IN connector of this monitor to the video output connector of digital disk recorder (or other recording devices) with a coaxial cable. • Connect the S-VIDEO IN connector of this monitor to the S-video output connector of digital disk recorder (or other recording devices) with an S-video cable. 13