Panasonic WV-NW502S Operating Instructions - Page 39
Unicast port1Image] *1, Available IPv6 address - operating instructions
View all Panasonic WV-NW502S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
[Refresh interval] Select an interval (I-frame interval; 0.2 - 5 seconds) to refresh the displayed H.264 images. If using under a network environment with frequent error occurrences, shorten the refresh interval for H.264 to diminish image distortions. However, the refresh interval may be longer than the set value. 0.2s/0.33s/0.5s/1s/2s/3s/4s/5s Default: 3s [Multicast address] *2 Enter the multicast IP address. Images and audio will be transmitted to the designated IP address. Available IPv4 address: 224.0.0.0 - 239.255.255.255 Available IPv6 address: Multicast address starting with "FF" Default: H.264(1): 239.192.0.20 H.264(2): 239.192.0.21 [Transmission type] Select a MPEG-4 transmission type from the following. Unicast port (AUTO): Up to 14 users can access a sin- gle camera concurrently. "Unicast port1(Image)" and "Unicast port2 (Audio)" will automatically be selected when transmitting images and audio from the camera. When it is unnecessary to fix the port number for H.264 image transmission such as when using in a particular LAN environment, it is recommended to select "Unicast port (AUTO)". Unicast port (MANUAL): Up to 14 users can access a single camera concurrently. It is necessary to select "Unicast port1(Image)" and "Unicast port2 (Audio)" manually to transmit images and audio from the camera. It is possible to fix the port number of the router used for H.264 image transmission via the Internet by setting "Unicast port (MANUAL)" ( page 74). Refer to the operating instructions of the router in use. Multicast: Unlimited number of users can access a single camera concurrently. Complete the entry field of "Multicast address", "Multicast port" and "Multicast TTL/HOPLimit" when transmitting H.264 images with multicast. * Refer to page 6 for further information about the maximum concurrent access number. Default: Unicast port (AUTO) [Unicast port1(Image)] *1 Enter the unicast port number (used to transmit images from the camera). Available port number: 1024 - 50000 (Only even num- bers are available.) Default: 32004 [Unicast port2(Audio)] *1 Enter the unicast port number (used to transmit audio from the camera). Available port number: 1024 - 50000 (Only even num- bers are available.) Default: 33004 Note: • Enter a multicast IP address after checking available multicast address. [Multicast port] *2 Enter the multicast port number (used to transmit images from the camera). Available port number: 1024 - 50000 (Only even num- bers are available.) Default: 37004 Note: • When audio is transmitted from the camera, the port number to be used will be the multicast port number plus "1 000". [Multicast TTL/HOPLimit] *2 Enter the multicast TTL/HOPLimit value. Available value: 1 - 254 Default: 16 Important: • When transmitting an H.264 image via a network, the transmitted image sometimes may not be displayed. In this case, refer to the network administrator. • When two or more network interface cards are installed on the PC in use, the network interface card(s) not used for receiving images should be invalidated when displaying images using the multicast port. *1 It is necessary to designate the unicast port number when "Unicast port (MANUAL)" is selected for "Transmission type". *2 It is necessary to designate the multicast IP address when "Multicast" is selected for "Transmission type". 39