Panasonic WV-NW502S Operating Instructions - Page 87
Troubleshooting
View all Panasonic WV-NW502S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Troubleshooting Before asking for repairs, check the symptoms with the following table. Contact your dealer if a problem cannot be solved even after checking and trying the solution in the table or a problem is not described below. Symptom Cause/solution Reference pages • Is the LAN cable (category 5 or better) firmly connected Installation to the network connector of the camera? Guide • Is the link LED lit? When it is not lit, connection to a LAN may not be established or a network may be not working correctly. Check if the cables have any contact failure or if the wiring is correct or not. Installation Guide Cannot access from the web browser. • Is the power of the camera on? Check if the power of the camera is turned on. • Are the set IP addresses valid? Installation Guide 72 • Are you accessing the wrong IP address? Check the connection as follows With the Windows command prompt, > ping "IP address of the camera" If there is reply from the recorder, the connection is - normal. If not, proceed either of the following. • Reboot the camera and change the IP address by using the Panasonic IP setup software within 20 minutes after the restart. • Reboot the camera while holding the [INITIAL SET] button on the camera. The camera will be initialized and the IP address will return to the default setting "192.168.0.10". 72 After the camera is initialized, access the camera and set the IP address again. (When the camera is initialized, all the settings of the camera previously configured on the setup menus will be initialized.) • Is "554" selected for the HTTP port number? For the HTTP port number, select a port number other than the following port numbers used by the camera. The number used by the camera: 20, 21, 23, 25, 42, 73 53, 67, 68, 69, 110, 123, 161, 162, 554, 995, 10 669, 10 670, 59 000 - 59 999, 60 000 - 61 000 87