Pentax AF360FGZ Operation Manual - Page 48
If the shutter speed is the same or slower than, not discharge.
UPC - 027075121041
View all Pentax AF360FGZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
When you turn the camera on and press the shutter release button halfway down, the channel is registered on the camera. 2 Next, set the channel of the separated (wireless) flash unit to the same channel as the flash unit attached to the camera. Place the other AF360FGZ in the desired position. Set the power switch of the flash unit to (WIRELESS). Set the wireless mode switch to (S), so that SLAVE is displayed in the upper right corner of the LCD panel. Slide down the setting switch to the (yellow dot) to display the channel on the LCD panel. Press the channel button (CH) and select the same channel that the flash unit attached to the camera has been set to. Slide the setting switch back up to the (white dot). ● The two flash units must be set to the same channel, otherwise the separated flash unit will not discharge. 3 Set the sync mode switch of the wireless flash unit to leading curtain sync ( ). 4 Set the exposure mode of the camera to manual exposure and the shutter speed faster than Xsync speed. ● If the shutter speed is the same or slower than the X-sync speed of the camera, the flash will be set to P-TTL mode, and when it is faster than Xsync speed, the flash will be set to high-speed sync mode. 5 Confirm that both flash units are fully charged, and take the photograph. A lamp on the wireless flash unit will blink. 46