Pentax IQZoom 928 IQZoom 928 Manual - Page 47

Correcting the date 1. Depress the Select button 0 to make a differ- ent category of digits on the LCD panel you want to change blink. 2. Depress the Adjust button 0 to change digits of the specified category you chose with the 0. Select button 0. Digits increase by one each time you depress the Adjust button Holding down the button will advance digits con- tinuously. • The blinking " : " allows precise fine-tuning of the internal clock to the beginning of a speci- • fled minute. To do so, depress the Select button 0 to make the " : " blink, and then depress the Adjust button 0 in sync with a time signal. 3. After the data has been adjusted, depress the Select button. The bar mark (-) appears on the LCD panel, indicating that data imprinting choices are possible. • If you release the shutter while the blinking data is being corrected, the data cannot be imprinted. • Numerical indication Year = 87-19 (1987-2019) Month = 1-12 Day = 1-31 Time = 0-23 Minute = 00-59 OPERATIONAL PRECAUTIONS The data on the LCD panel is imprinted on each frame you expose. • "Year-Month-Day" and "Day-Hour-Minute" cannot be imprinted at the same time. • As you release the shutter, the bar (-) mark on the display blinks for a few seconds, indicating the data has been imprinted. • Move the panorama mode selector lever to the right or left to switch the imprint mode between panorama and standard. • The dating unit automatically switches the imprint mode between the standard and panorama according to the format mode selected. • If there is a white or yellow object in the corner of the picture where the data is imprinted, the data may be difficult to read. When composing your photographs, try to avoid brightly-colored subjects in that corner. 43