Pentax ZX-L ZX-L Manual - Page 45
Adjusting, hour/minute.
View all Pentax ZX-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
SNOLLVIARd0 0ISVEI fitrLfiUtIVU f f1t b/il t tt -ifLJ g 2 Adjusting the hour/minute. TPress the [SELECT] button to make the hour, minute or second ( : ) you want to change blink. trza The digits blink in the following order. Hour Minute : Hour ®Change the data ( hour or minute ) with the [ADJUST] button. ]Memo The digit increases by one each time the [ADJUST] button is depressed. Holding the button for about 2 to 3 seconds will change the digits continuously. ©To change the second ( : ), press the [SELECT] button until " :" will blink, and then press the [ADJUST] button in sync with a time signal to set the second to zero. ()Press the [SELECT] button to stop the adjusted hour/minute from blinking. Memo Operational precautions • To select or cancel the date imprinting or to select the format, see "Imprinting the Date and Time" on page 16. • If the imprinting looks too light or if the Data back's display looks light. or shows nothing, replace the Data back's battery. (OF p.40) • The working temperature for data printing is 0°C - 50°C (32°F - 122°F). • Imprinted data may appear too light under the low temperature. • Use DX-coded films with ISO rating from 25 - 1600. • If high-speed film with an ISO rating of 1000 or faster is used, the imprinted characters may blur. • If film with ISO rating of 50 or slower is used, the printed characters may be dark or dim. • If you release the shutter while the blinking data is being corrected, the data cannot be imprinted.