Pfaff GrandQuilter 18.8 Owner's Manual - Page 8

Connecting your Grand Quilter 18.8 to your Carriage Assembly (Deck) and Controls on the Handles For one year after the purchase of the Pfaff GrandQuilter 18.8 longarm sewing machine, we will repair or replace (at our option), without any cost to you for either parts or labor, any machine or part that proves to be defective in materials or workmanship. Any cables that the Purchaser needs to connect must be connected with care. Careless connection or disconnection may result in damage to the cables and/or components that the cables are connected to. Such damage is not covered under warranty. Your Carriage Assembly (Deck) comes without the encoders and cables connected. You will have a sheet with your machine to show how to attach these encoders so that the stitch regulations will work. This cable is routed to the power box of your machine and plugged into the receptacle on the back of the power box. This is looking at the back of your machine. You can see the three connecting receptacles in the back of the machine. The bottom one is for your Carriage Assembly (deck). The next one up is for your controls from the handle bars. The top one is not used at this time. Your left and right controls on your handle bar have a cable that runs through the handle bar to connect the two controllers. You will need to use the supplied Handle Bar Cable (9 pin) to connect your left handle controller to connector on the back of the power box. The Handle Bar Cable (9 pin) Your Handle Bar Cable (9 pin) Cable connects to the Controller on the Left handle. Note this Handle Bar (9 pin) only connects to this left controller. 8