Philips DVDR80 User manual - Page 10

10 Hookups (cont'd) Connecting to a TV Only TV has only an Antenna In jack Antenna or Cable TV Signal MAINS Back of TV (example only) IN - EXT 2 VIDEO (CVBS) ANTENNA IN - EXT 1 AUDIO COMPONENT VIDEO Y OUT 2 OUT 1 480p/480i VIDEO AUDIO COMPONENT (CVBS) VIDEO Y S-VIDEO S-VIDEO (Y/C) (Y/C) L PB L PB AUDIO AUDIO TV R PR R PR DIGITAL AUDIO OUT G-LINK DIGITAL AUDIO OUT COAX OUT OPTICAL OUT 1 Connect your Antenna or Cable TV signal to the ANTENNA jack on the rear of the Recorder. Your antenna or Cable TV signal may have been connected to your TV already. If so, disconnect it from the TV and connect it to the Recorder's ANTENNA jack. 2 Connect the supplied RF coaxial cable to the TV jack on the rear of the Recorder. Connect the other end of the same RF coaxial cable to the Antenna In jack on your TV. Your TV's Antenna In jack may be labelled RF In,Antenna In, or 75 ohm. Check your TV's manual for details. 3 Connect the supplied power cord to the MAINS ~ (AC Power) jack on the rear of the Recorder. Connect the power cords of the Recorder and the TV to a power outlet. 4 Press STANDBY-ON y on the front of the Recorder to turn it on. "IS TV ON? CH03" will appear on the Recorder's display panel the first time you turn on the Recorder. 5 Turn on the TV. Set it to channel 3. You should see the blue Philips DVD background picture or the Initial Setup screen. Initial Setup appears the first time you turn on the Recorder. Go to pages 18-20 to complete the Initial Setup. Helpful Hints • The Recorder's display may show "IS TV ON? C04" instead. If so, put the TV on channel 4. • If you need to use TV channel 4 but "IS TV ON? C03" appears on the display, press and hold the Number 4 button on the Recorder's remote. After several seconds, the display will change to "IS TV ON? C04." Set your TV to channel 4. Likewise, if the display shows "IS TV ON? C04" and you need TV channel 3, press and hold the Number 3 button. Use this procedure while the Recorder is on and "IS TV ON?..." shows on the display.