Philips MCM530 User manual - Page 23

English Timer Operations Timer setting The system can switch on to CD,TUNER or USB PC LINK mode automatically at a preset time, serving as an alarm to wake you up. IMPORTANT! - Before setting the timer, ensure that the clock is set correctly. - The volume of the timer will increase gradually to the last tuned volume level. If the last tuned volume level is too low, the set will then increase to a predetermined minimum audible level. 2 (CD / TUNER / USB PC LINK) 3 (00:00 / 12:00AM) 1 3 (00:00 / 12:00AM) 1, 4 1 Press and hold TIMER on the remote until icon starts flashing. OR Press and hold CLOCK•TIMER on the main unit until "SELECT CLOCK OR TIMER" is displayed. Then press ë to change the display to "TIMER" and press CLOCK•TIMER again to confirm. 2 Press CD or TUNER or USB PC LINK to select the wake-up source. ➜ The selected source will be lighted while other available sources are flashing. 3 Press à or á (for hours) and í or ë (for minutes) repeatedly to set the wake up time. 4 Press TIMER (or CLOCK•TIMER) to store the setting. ➜ The timer will always be switched on after it has been set. ➜ icon remains on the display. It indicates the timer is activated. ● At the preset time, the selected sound source will be played for 30 minutes before it switches to Eco Power standby mode (if no button is being pressed within the time frame). ➜ CD - playing the first track of the last selected disc. If the last selected disc tray is empty, it will switch to the next available disc. If all the disc trays are not available, it will switch to Tuner mode. ➜ TUNER - playing the last tuned radio station. ➜ USB PC LINK - playing the last selected playlist. If the connection fails, it will switch to Tuner mode. Refer to "USB PC Link" for proper connection and setup before use. Activating/Deactivating the timer ● Press TIMER ON/OFF on the remote to turn off the timer or turn on to the last setting again. ➜ If activated, the timer information will display for a few seconds, then the system resumes to the last active source or stays in standby mode. ➜ If deactivated,"OFF" is displayed. Note: - The system will exit timer setting mode if no button is pressed within 90 seconds. Checking the timer setting ● Press TIMER on the remote. ➜ The timer information will display for a few seconds, then the system resumes to the last active source or stays in standby mode. 23