Philips MCM530 User manual - Page 26

English Troubleshooting WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help. Problem Auto Installation of the Installer CD-ROM did not install the Philips Sound Agent 2 onto my PC. Solution ✔ Check that your PC's Operating System is running on Windows 2000/XP. When in USB PC LINK mode, "NO CONNECTION" is displayed. I want the minimum effect from the Philips Sound Agent 2 sound mode when listening to MP3 music streaming via USB PC Link. ✔ Check the connection between your PC and the system and the inital setup required, see "Connections" and "USB PC Link". ✔ Make sure the connected PC is turned on. ✔ Select the PRESET - Neutral mode. ✔ Select the REVERB - No environment mode. Radio reception is poor. ✔ If the signal is too weak, adjust the antenna or connect an external antenna for better reception. ✔ Increase the distance between the system and your TV or VCR. "NO DISC" is displayed or the disc cannot be played. ✔ Insert a disc. ✔ Load in the disc with label facing right. ✔ Replace or clean the disc, see "Care and safety information". ✔ Use a finalised CD-R(W) or a correct format disc. The system does not react when buttons are pressed. ✔ Remove and reconnect the AC power cord and switch on the system again. Sound cannot be heard or is of poor quality. ✔ Adjust the volume. ✔ Disconnect the headphones. ✔ Check that the speakers are connected correctly. ✔ Check that the AC power cord is connected properly. ✔ When in USB PC LINK mode, check that the PC's volume is not put into mute. ✔ When playing CD from PC's CD drive, refer to "USB PC Link - Enable digital CD audio output". The remote control does not function properly. ✔ Select the source (CD or TUNER, for example) before pressing the function button (ÉÅ, S , T). ✔ Reduce the distance between the remote control and the system. ✔ Replace the battery. ✔ Point the remote control directly toward the IR sensor. The timer is not working. ✔ Set the clock correctly. ✔ Press TIMER ON/OFF to switch on the timer. The system displays features automatically and ✔ Press and hold STOP DEMO on the main unit to switch buttons start flashing. off the demonstration mode. 26