Pioneer AVH-P5200BT Installation Manual - Page 2
Contents, Connecting the units - install
UPC - 012562975900
View all Pioneer AVH-P5200BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Contents Connecting the units Connecting the units 2 Connecting the power cord 4 When connecting to separately sold power amp 6 When connecting with a rear view camera 7 When connecting the external video component and the display 8 When using a display connected to rear video output 8 Connecting the system 8 Installation 9 DIN front/rear-mount 9 DIN Front-mount 9 DIN Rear-mount 10 Removing the unit 10 Fastening the front panel 10 Installing the microphone (AVH-P5200BT only 11 When installing the microphone on the sun visor 11 When installing the microphone on the steering column 11 Adjusting the microphone angle 11 WARNING • To avoid the risk of accident and the potential violation of applicable laws, the front DVD (sold separately) feature should never be used while the vehicle is being driven. Also, rear displays should not be in a location where it is a visible distraction to the driver. • In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit's DVD features should not be used. CAUTION • PIONEER does not recommend that you install or service your display yourself. Installing or servicing the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your display to authorized Pioneer service personnel. • Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed. • Do not drill a hole into the engine compartment to connect the yellow lead of the unit to the vehicle battery. Engine vibration may eventually cause the insulation to fail at the point where the wire passes from the passenger compartment into the engine compartment. Take extra care in securing the wire at this point. • It is extremely dangerous to allow the display lead to become wound around the steering column or gearshift. Be sure to install the display in such a way that it will not obstruct driving. • Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat sliding mechanism. • Do not shorten any leads. If you do, the protection circuit may fail to work properly. WARNING LIGHT GREEN LEAD AT POWER CONNECTOR IS DESIGNED TO DETECT PARKED STATUS AND MUST BE CONNECTED TO THE POWER SUPPLY SIDE OF THE PARKING BRAKE SWITCH. IMPROPER CONNECTION OR USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW AND MAY RESULT IN SERIOUS INJURY OR DAMAGE. 2