Pioneer AVH-P6600DVD Owner's Manual - Page 78
Adjusting the speaker output, levels using a test tone, Using the time alignment, Digital Signal
UPC - 012562682853
View all Pioneer AVH-P6600DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Section 15 Digital Signal Processor 3 Touch or to select the speaker to be adjusted. Each time you touch or selects the speaker in the following order: FRONT-L (front speaker left)CENTER (center speaker)FRONT-R (front speaker right) REAR-R (rear speaker right)REAR-L (rear speaker left)SUB WOOFER (subwoofer) # You cannot select speakers whose size is set at OFF. 4 Touch or to adjust the speaker output level. Each time you touch or increases or decreases the speaker output level. +10 10 is displayed as the level is increased or decreased. Note To adjust the speaker output levels in this mode is the same as making the speaker output levels at TEST TONE. Both provide the same results. Adjusting the speaker output levels using a test tone A convenient test tone allows you to easily get the overall balance right among the speakers. 1 Touch A.MENU and DSP and then touch NEXT. 2 Touch TEST TONE. 3 Touch START to start the test tone output. The test tone is outputted. It rotates from speaker to speaker in the following sequence at intervals of about two seconds. The current settings for the speaker over which you hear the test tone are shown in the display. FRONT-L (front speaker left)CENTER (center speaker)FRONT-R (front speaker right) REAR-R (rear speaker right)REAR-L (rear speaker left)SUB WOOFER (subwoofer) Check each speaker output level. If no adjustments are needed, perform step 5 to stop the test tone. # You can also start the test tone output by moving the joystick up. # The settings do not appear for speakers whose size is set OFF. 4 Touch or to adjust the speaker output level. Each time you touch or increases or decreases the speaker output level. +10 10 is displayed as the level is increased or decreased. # The test tone rotates to the next speaker after about two seconds from the last operation. 5 Touch STOP to stop the test tone output. # You can also stop the test tone output by moving the joystick down. Notes ! If needed, select speakers and adjust their absolute output levels. (Refer to Adjusting the speaker output levels on the previous page.) ! To adjust the speaker output levels in this mode is the same as making the speaker output levels at SPEAKER LEVEL. Both provide the same results. Using the time alignment Only when the multi-channel processor (e.g., DEQ-P8000) is connected to this unit, you can operate this function. 78 En