Pioneer AVIC-D3 Other Manual - Page 6

Connecting the System Before installing this product • This product is for vehicles with a 12-volt battery and negative grounding. Check the battery voltage of your vehicle before installation. • To avoid shorts in the electrical system, be sure to disconnect the (-) battery cable before beginning installation. To prevent damage When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product. • When disconnecting a connector, pull the connector itself. Do not pull the lead, as you may pull it out of the connector. • This product cannot be installed in a vehicle that does not have an ACC (accessory) position on the ignition switch. F ACC O F O OF OF N STAR N STAR T T ACC position No ACC position • When the "ANT CTRL" mode is set to "Tuner", the vehicle's antenna can be stowed or turned off by following the instructions below. - Change the source from radio (AM or FM) to another source - Turn the source off - Turn off the ignition switch (ACC OFF) • If the "ANT CTRL" mode is set to "Power", the vehicle's antenna can be stowed or turned off only when the ignition switch is turned off (ACC OFF). • To avoid short-circuiting, cover the disconnected lead with insulating tape. It is especially important to insulate all unused speaker leads, which if left uncovered may cause a short circuit. • Attach the connectors of the same color to the corresponding colored port, i.e., blue connector to the blue port, black to black, etc. • Refer to the owner's manual for details on connecting the power amp and other units, then make connections accordingly. • Since a unique BPTL circuit is employed, do not directly ground the ≠ side of the speaker lead or connect the ≠ sides of the speaker leads together. Be sure to connect the ≠ side of the speaker lead to the ≠ side of the speaker lead on this navigation system. • If the RCA pin jack on this product will not be used, do not remove the caps attached to the end of the connector. 5