Pioneer AVIC-W6500NEX Owners Manual - Page 148
Performing Auto EQ
View all Pioneer AVIC-W6500NEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
English - Rear speakers (left/right) - Noise - Microphone for acoustical measurement (sold separately) - Low battery ▶Performing Auto EQ CAUTION Do not turn off the engine while the measurement is in progress. NOTES • Auto EQ changes the audio settings as follows: - The fader/balance settings return to the center position (page 144). • Previous settings for Auto EQ will be overwritten. 1 Stop the vehicle in a quiet place, close all doors, windows, and sun roof, and then turn the engine off. If the engine is left running, engine noise may prevent correct Auto EQ. NOTE If driving restrictions are detected during measurement, the measurement is canceled. 2 Fix the microphone for acoustical measurement (sold separately) in the center of the headrest of the driver's seat, facing forward. The Auto EQ may differ depending on where you place the microphone. If desired, place the microphone on the front passenger seat and perform Auto EQ. 3 Disconnect the iPhone or smartphone device. 4 Turn on the ignition switch (ACC ON). If the vehicle's air conditioner or heater is turned on, turn it off. 5 Switch the AV source to [Source OFF] (page 73). 6 Press . 7 Touch then . 8 Touch [A-EQ&TA Measurement]. 9 Connect the microphone for acoustical measurement (sold separately) with this product. W8500NEX Plug the microphone into the Auto EQ microphone input jack on this product (page 6). W6500NEX Plug the microphone into the AUX input jack on the back panel of this product (refer to the Installation Manual). - 148 -