Pioneer AVIC-W6500NEX Owners Manual - Page 161
Error messages
View all Pioneer AVIC-W6500NEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
English occurs when the reverse gear polarity setting of this product is incorrect. - Check the polarity and re-select the correct setting. Error messages When problems occur with this product, an error message appears on the display. Refer to the table below to identify the problem, then take the suggested corrective action. If the error persists, record the error message and contact your dealer or your nearest Pioneer service center. Common AMP Error → This product fails to operate or the speaker connection is incorrect; the protective circuit is activated. - Check the speaker connection. If the message fails to disappear even after the engine is switched off/on, contact your dealer or an authorized Pioneer Service Station for assistance. TEMP → The temperature of this product is outside the normal operating range. - Wait until this product returns to a temperature within the normal operating limits. Product overheat. System will be shut down automatically in 1 minute. Restart the product by ACC-Off/On may fix this problem. If this message keeps showing up, it is possible that some problem occured in the product. → The temperature is too high for this product to operate. - Follow the instructions displayed on the screen. If this does not solve the problem, contact your dealer or an authorized Pioneer Station for assistance. Positioning is not possible due to the hardware. Please contact your dealer or Pioneer service center. → The location display is not possible due to hardware failure. - Contact your dealer or an authorized Pioneer Station for assistance. No GPS antenna. Check connection. → GPS reception is lost. - Check the antenna connection. If the message fails to disappear even after the engine is switched off/on, contact your dealer or an authorized Pioneer Station for assistance. GPS antenna problem detected. Contact dealer or service center. → GPS antenna lead is short-circuited. - Contact your dealer or an authorized Pioneer Station for assistance. Calibration will start, but may be inaccurate without speed pulse. → The speed pulse sensor is not connected correctly. - Contact your dealer or an authorized Pioneer Station for assistance. Sensor error. Please contact your dealer or Pioneer Service Center. → An error has occurred with the sensor. - Contact your dealer or an authorized Pioneer Station for assistance. Detected unusual speed pulses. → The speed pulse cannot be detected correctly. - Contact your dealer or an authorized Pioneer Station for assistance. - 161 -