Pioneer CDJ 100S Owner's Manual - Page 15

OTHERS: TROUBLESHOOTING Symptom Cause Remedy When the auto cue function is set ON, track search is not finished. ÷ If the sound muted portion between selections is long, searching time will be long. ÷ If the sound muted portion is recorded for about 20 seconds or more, playback will start without the auto cue function. ÷ Press TIME MODE/AUTO CUE button for more than 1 second to set the auto cue function OFF. Back cue function cannot be carried out even though the CUE button is pressed in playback mode. ÷ The cue point is not set yet. ÷ Set the cue point. (See page 10.) DJ mode doesn't work. ÷ DIGITAL OUT switch is set to ON (dig- ÷ Set DIGITAL OUT switch to OFF. ital output is effective). The picture of the TV screen is ÷ Interference is being picked up from ÷ Turn off POWER of the player, or move fluctuated or FM broadcast is the CD player. the player away from the TV or tuner. interfered with noise. The disc is not rotating when power is ON. ÷ The disc rotation stops automatically if no operation has been performed for 80 minutes or more in pause mode. ÷ Playback can be started by pressing the PLAY/PAUSE button. Press the EJECT button to eject the disc. ¶ Static electricity and other external effects may cause this unit to malfunction. In this case, set the power switch to OFF, then switch it on again after the disc has come to a complete stop. ¶ This unit cannot playback non-finalized CD-R discs (partial discs). ¶ This component is designed to play both ordinary 12 cm (5-inch) discs and 8 cm (3-inch) discs mounted on adapters. Non-round (eccentrically shaped discs) cannot be played, since damage or malfunction may result. Error display When the player detects an error during operation, if will immediately stop and display an error code in the display window. Check the error code with those listed in the table below to determine the cause of error. Contact your nearest Pioneer authorized service center if the cause of the error is unknown, too difficult to fix or if the same error code continues to display after the remedy has been tried. Refer to the error code when speaking to the Pioneer service representative. Displayed error code number Type of error Error contents Possible Cause = Remedy E-72 01 E-72 02 E-83 01 TOC READ ERROR FG PULSE ERROR PLAYER ERROR TOC date cannot be read after 20 seconds. Disc is rotating, but rotation cannot be ascertained. Disc loaded cannot be played properly. Disc has scratch = Replace disc Disc is dirty = Clean disc E-83 02 PLAYER ERROR Disc loaded cannot be played properly. E-91 01 E-91 03 MECHANICAL TIME OUT MECHANICAL TIME OUT Mechanical operation did not end in allotted time. Mechanical operation did not end in allotted time. Foreign object is in disc compartment slot. = Remove it. Should this product require service in the U.S.A. and you wish to locate the nearest Pioneer Authorized Independent Service Company, or if you wish to purchase replacement parts, operating instructions, service manuals, or accessories, please call the number shown below. 800 - 872 - 4159 Please do not ship your product to Pioneer without first calling the Customer Service Department at the above listed number for assistance. PIONEER ELECTRONICS SERVICE, INC. CUSTOMER SUPPORT DIVISION P.O. BOX 1760, LONG BEACH, CA 90801-1760, U.S.A. For warranty information please see the Limited Warranty sheet included with your product. Should this product require service in Canada, please contact a Pioneer Canadian Authorized Dealer to locate the nearest Pioneer Authorized Service Company in Canada. Alternatively, please contact the Customer Service Department at the following address: Pioneer Electronics of Canada, Inc. 300 Allstate Parkway Markham, ON L3R 0P2 (905) 479-4411 For warranty information please see the Limited Warranty sheet included with your product. 15 En