Pioneer CLD-V2800 CLD-V8000 User's Manual31178843 - Page 18

CLD-V2800 Level II • Chapter Two 2.3 Function Switches The CLD-V2800 videodisc player has four physical dip-switches, #1-4, on the rear panel of the player (See Figure 2-G below.) These are used to set several function parameters. All switches are set as follows when the players are shipped from the factory: Switch 1: DOWN and Switch 2: UP sets the BAUD set to 4800; Switch 3: UP Auto Start set to OFF; Switch 4: UP Squelch is Blue. Function Switch Settings 12 34 CLD-V2800 has 4 function switches on the back of the player. After changing the switches to new settings, power down and then power on the player again to commit the settings to the player's memory. Switch # Function DOWN UP Factory Setting Set BAUD Rate w/ SW1 & 2 Sw 1 Sw 2 Sw 3 Sw 4 BAUD Rate BAUD Rate These two switches are used to set the BAUD RATE: 9600, 4800, 2400 or 1200 Auto Start Auto Start No Start Background Black Blue SW1=DOWN, SW2=UP sets 4800 BAUD UP/No Start UP/Blue BAUD SW 1 SW2 9600 UP UP 4800 DOWN UP 2400 UP DOWN 1200 DOWN DOWN Figure 2-G SW1 and SW2: These two switches are used to set the BAUD rate of the Player for RS-232C communications to 9600, 4800, 2400, or 1200 BAUD. The factory set default is 4800 BAUD, with Switch 1 DOWN and Switch 2 UP. SW3: Auto Start Automatic playback starts when a disc is inserted and SW3 is DOWN=ON. Default is No Auto Start: UP=OFF. SW4: Background for setting squelch color: Black is DOWN=ON; Blue is UP=OFF. Default is Blue: UP=OFF. NOTE: Settings for Load Start, Power-On Start, 4800 or 1200 BAUD Rate, and Background Color can be modified by entering data into Register C from a computer via the RS-232C port. (See Section 3.7.6 Register Control Commands, Register C Set, page 3-42.) 2-6 TP 120 v. 1.0 • 10/95 CLD-V2800 Level III User's Manual