Pioneer CLD-V2800 CLD-V8000 User's Manual31178843 - Page 59

Chapter Three • CLD-V2800 Level III Line 0 is used for displaying chapter, frame, time and track numbers. Chapter (CAV or CLV) (2) Track-Index (CD) (4) Frame (CAV) or Time (CLV) (5) Time or Time+ Block (CD) (4 or 6) Line 0 Line 1 2 3 4 5 6 7 8 9 ssssssssssssssssssss ssssssssssssssssssss ssssssssssssssssssss ssssssssssssssssssss s s s s s s s User's Area s s s s s s s s s s s 10 lines x 20 Characters s s s s ssssssssssssssssssss ssssssssssssssssssss ssssssssssssssssssss ssssssssssssssssssss Figure 3-S Line 0 and 1 are sometimes used for displaying remote control inputs. Line 2 to 9 are used exclusively as the User's Display Area on the CLDV2800. If all lines of the User's Display Area are required for user defined messages, the 4RA command can be sent to the player. This will reserve all lines (including lines 0 and 1) in the display for user messages. NOTE: Lines 0 & 1 are usually reserved for frame/time and chapter/track addresses and the address flag status. To activate the User Display Area: • Set the User's Display using the Register A command. • Turn ON the display switch. (1DS) • Identify the line on which the characters will appear by using the Print Character command (PR) . (See page 3-30.) • Then send the character string to be displayed followed by . NOTE: The display switch can be turned ON or OFF at any time. However, if Register A is changed so that the User's Display Area is disabled, the contents of the User's Display Area will be cleared. Also, if the Print Character command is issued before Register A is set for the User's Display Area, the character string will not be seen. The Power-On default for display control is 3RA. This allows Frame/Time, Chapter/Track numbers to be seen when the display is turned on, depending on the type of disc that is in the tray. Register A may be changed for different displays. See example below: 3-40 TP 120 v. 1.0 • 10/95 CLD-V2800 Level III User's Manual