Pioneer DEH-3200UB Owner's Manual - Page 14

Section 02 Operating this unit This unit is equipped with a subwoofer output which can be turned on or off. 1 Press M.C. to display the setting mode. 2 Turn M.C. to select the desired setting. Normal (normal phase)-Reverse (reverse phase)-OFF (subwoofer off) 3 Press M.C. to confirm the selection. SW setting 2 (subwoofer adjustment) When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. Only frequencies lower than those in the selected range are outputted from the subwoofer. 1 Press M.C. to display the setting mode. 2 Press M.C. to cycle between cut-off frequency and output level of subwoofer. 3 Press M.C. to switch to cut-off frequency and then turn M.C. to select cut-off frequency. 50Hz-63Hz-80Hz-100Hz-125Hz 4 Press M.C. to switch to output level and then turn M.C. to adjust output level. Adjustment range: +6 to -24 HPF setting (high pass filter adjustment) When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers. 1 Press M.C. to display the setting mode. 2 Turn M.C. to select cut-off frequency. OFF (off)-50Hz-63Hz-80Hz-100Hz-125Hz 3 Press M.C. to confirm the selection. Bass booster (bass boost) 1 Press M.C. to display the setting mode. 2 Turn M.C. to adjust the level. Adjustment range: 0 to +6 3 Press M.C. to confirm the selection. SLA (source level adjustment) SLA (Source level adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. ! When selecting FM as the source, you cannot switch to SLA. ! Settings are based on the FM volume level, which remains unchanged. Before adjusting source levels, compare the FM volume level with the level of the source you wish to adjust. ! The AM volume level can also be adjusted with source level adjustments. 1 Press M.C. to display the setting mode. 2 Turn M.C. to adjust the source volume. Adjustment range: +4 to -4 3 Press M.C. to confirm the selection. Note Operation is complete even if the menu is cancelled before being confirmed. Initial Settings 1 Press SRC/OFF and hold until the unit turns off. 2 Press M.C. and hold until the initial setting menu appears in the display. 3 Turn M.C. to select the initial setting. After selecting, perform the following procedures to set the initial setting. Clock set (setting the clock) 1 Press M.C. to display the setting mode. 2 Press M.C. to select the segment of the clock dis- play you wish to set. Hour-Minute As you select segments of the clock display, the selected segment flashes. 3 Turn M.C. to adjust the clock. Clock (clock on/off setting) 1 Press M.C. to turn the clock display on or off. AUX (auxiliary input) Activate this setting when using auxiliary device connected to this unit. 1 Press M.C. to turn AUX on or off. 14 En