Pioneer DVL-909 Service Guide - Page 17
DV-505, DVL-909, DV-S9, 7 Test Mode Screen Display The Second Generation - region
View all Pioneer DVL-909 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
DV-505, DVL-909, DV-S9 Special Mention Item (1) Indications for the spindle status are as follows: A/B : Spindle accelerator and brake FG : FG servo SRV : Rough, velocity/phase servo O_S : Offset addition, rough, velocity/phase servo (2) The movement of loading in/out starts from the tray open status. After that, this function is executed unless a play and close operation are done. (3) There are three methods for entering a search address: Absolute address designation → Searching for the address entered (indication for the most significant digit :>) Additional input → Searching for the address with the current ID number plus an entered number (indication for the most significant digit :+) Subtractive input → Searching for the address with the current ID number minus an entered number(indication for the most significant digit :-) The above modes can be changed by pressing [10] key. Note : A number for addition or subtraction must be entered in hexadecimal. (4) If you turn the power on while short-circuiting the short-circuit terminal at the side of the system controller, the player will forcibly enter the test mode. If the FL controller is set to Checker mode, disc sensing will not be started, even if a disc is loaded. Disc sensing will also not be performed if the tray is opend/ closed by your pressing [REPEAT A] key while in Checker mode. However, disc sensing will be started if the [OPEN/CLOSE] key on the player or on the remote control unit is pressed. (5) If disc-type designation is forcibly executed during a mode other than Checker mode, the system controller will abandon disctype designation after setting the mechanism controller. Therefore, after startup of the player, disc sensing will be performed again for safety. If disc-type designation is forcibly executed during Checker mode, as disc-type designation is not abandoned, playback will be immediately started. (6) A background color change in order of blue → green → light blue → red → purple → yellow → gray → black → with the [2/ R] key. It changes in order of gray → yellow → purple → red → light blue → green → blue → black → in the case of the [1/L] key. (7) In case of PD0260A∗, tilt servo on function may not move with DVD. 3.7 Test Mode Screen Display (The Second Generation) Consecutive double-OSD display is supported during test mode. The screen is composed 10 lines with a maximum of 32 characters per line. It can't be used with the debugging display mode together. • Screen Composition Address Tilt error value, Tilt servo status Tracking status Spindle status AGC setting Character in bold : Item name : Information display FTS servo IC information Remote control code Key code Mechanical position value Slider position Output video system AV1 classification and Flash ROM size FL controller version Region setting for the player C1 error value of CD and DVD Internal operation mode of the mechanism control Disc judgment Pickup First screen display Flash ROM version System controller revision DVD mechanism controller revision AV-1 chip version CLD mechanism controller revision Caution : The first screen and second screen switch by pressing [DISPLAY] key of the remote control unit. It is only a version display part on the lower right of the screen those contents of display change. ATB : ON/OFF information display and AGC manual establishment display deleted with the second generation. FL controller version GUI-ROM number Part No. of flash ROM and system controller Part No. of DVD mechanism controller Part No. of CLD mechanism controller Second screen display (at lower right portion of the screen) 17