Pioneer FHD1 Owner's Manual - Page 21

Operation 07 Operation Plasma Display status indicators The table below shows the operational status of the Plasma Display. You can check the current status of the Plasma Display with the indicators on the Plasma Display. English STANDBY indicator POWER ON indicator MAIN POWER switch Indicator Status POWER ON STANDBY Plasma Display Status The power cord of the Plasma Display has been disconnected. Or, the power cord of the Plasma Display has been connected but the MAIN POWER switch of the Plasma Display is off. Power to the Plasma Display is on. The Plasma Display is in the standby mode. Flashing With the Power Management function (page 29) set to "On", no signal was detected, with the result that the unit switched to the standby mode. The unit will turn back ON, under one of the following conditions: • The main unit's INPUT is pressed; • One of the remote control unit's INPUT 1 to INPUT 6 is pressed; • An input signal is detected once again. (Repeatedly lights 1 second, then goes out 1 second) Flashing The unit's protection circuit may have operated. Press the MAIN POWER switch to turn the unit off, then wait one minute before turning the unit on again. (The indicator will light 1 second, then go out for 1 second; after several repeats, the indicator will go out for 2.5 seconds, and then the cycle will repeat.) Flashing (The indicator will light 1 second, then go out for 1 second; after several repeats, the indicator will go out for 2.5 seconds, and then the cycle will repeat.) For other than the above, see Troubleshooting on page 38. Changing the volume and sound Using VOLUME +/- • To increase the volume, press VOLUME +. • To decrease the volume, press VOLUME -. Using MUTING on the remote control unit MUTING mutes the current sound output. 1 Press MUTING. • MUTING appears on the screen. 2 Press MUTING again to cancel the mute mode. • Pressing VOLUME + also cancels the mute mode. SPLIT VOLUME MUTING SUB INPUT Volume adjustment Muting 21 En