Pioneer VSX-90TXV Owner's Manual - Page 60

10 Using other functions Dimming the display You can choose between four brightness levels for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds. CD-R/TAPE CD iPod ZONE 2 TUNER RECEIVER SLEEP SR+ DIALOG E SB ch DIMMER PHASE ANALOG ATT MIDNIGHT/ LOUDNESS S.RETRIEVER D ACCESS • Press RECEIVER then press DIMMER repeatedly to change the brightness of the front panel display. Switching the speaker impedance We recommend using speakers of 8 Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6 Ω impedance rating. Use the front panel controls to do this. • With the receiver in standby, press  STANDBY/ ON while holding down the SPEAKERS button. Each time you do this, you switch between the impedance settings: • SP 6 OHM - Use this setting if your speakers are rated at 6 Ω. • SP 8 OHM - Use this setting if your speakers are rated at 8 Ω or more. Resetting the system Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this. 1 Switch the receiver into standby. 2 While holding down the front panel TONE button, press and hold  STANDBY/ON for about three seconds. The display shows RESET?. 3 Press the front panel ENTER button. The display shows RESET OK?. 4 Press SYSTEM SETUP to confirm. OK appears in the display to indicate that the receiver has been reset to the factory default settings. • Note that all settings will be saved, even if the receiver is unplugged. 60 En