Pioneer VSX-90TXV Owner's Manual - Page 61
Controlling the rest of your system - model
View all Pioneer VSX-90TXV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Controlling the rest of your system 11 Chapter 11: Controlling the rest of your system Setting the remote to control other components Most components can be assigned to one of the input source buttons (such as DVD/LD or CD) using the component's manufacturer preset code stored in the remote. However, there are cases where only certain functions may be controllable after assigning the proper preset code, or the codes for the manufacturer in the remote control will not work for the model that you are using. Note • You can cancel or exit any of the steps by pressing RECEIVER. To go back a step, press RETURN. • After one minute of inactivity, the remote automatically exits the operation. Selecting preset codes directly To try out the remote control, switch the component on or off (into standby) by pressing SOURCE . If it doesn't seem to work, select the next code from the list (if there is one). 7 If your component is controlled successfully, press ENTER to confirm. The remote LCD display shows OK. Resetting the remote control presets This will erase all preset remote control preset codes and programmed buttons. 1 While pressing the RECEIVER button, press SETUP. The remote LCD display shows SETUP. 2 Use / to select RESET then press ENTER. RESET flashes in the LCD display. 3 Press and hold ENTER for about two seconds. The LCD shows OK to confirm the remote presets have been erased. XM RADIO DVD CD-R/TAPE CD SIRIUS TV iPod DVR 2 DVR 1 TV CTRL ZONE 2 TUNER RECEIVER SLEEP SB ch ANALOG ATT TOP MENU TUNE ST SETUP ENTER MENU ST T.EDIT RETURN GUIDE TUNE TV CONTROL BAND 1 While pressing the RECEIVER button, press SETUP. The remote LCD display shows SETUP. 2 Use / to select PRESET then press ENTER. 3 Press the input source button for the component you want to control then press ENTER. The LCD on the remote displays the component you want to control (for example DVD or DVR).1 4 Use / to select the first letter of the brand name of your component then press ENTER. This should be the manufacturer's name (for example, P for Pioneer). 5 Use / to select the manufacturer's name from the list then press ENTER. 6 Use / to select the proper code from the list, then try using this remote with your component. The code should start with the component type (for example, DVD 020). If there is more than one, start with the first one.2 Confirming preset codes Use this feature to check which preset code is assigned to an input source button. 1 While pressing the RECEIVER button, press SETUP. The remote LCD display shows SETUP. 2 Use / to select READ ID then press ENTER. The LCD on the remote prompts you for the input source button you want to check. 3 Press the button of the component for which you want to check the preset code, then press ENTER. The brand name and preset code appears in the display for three seconds. Direct function • Default setting: ON You can use the direct function feature to control one component using the remote control while at the same time, using your receiver to playback a different component. This could let you, for example, use the remote control to set up and listen to a CD on the receiver and then use the remote control to rewind a tape in your VCR while you continue to listen to your CD player. Note 1 You can't assign the RECEIVER, TUNER, XM RADIO, SIRIUS or iPod buttons. 2 • When using a Pioneer HDD recorder, please select PIONEER DVR 487, 488, 489 or 493. • When using a Pioneer plasma display released prior to summer 2005, please select preset codes 637 or 660. 61 En