Pioneer VSX-90TXV Owner's Manual - Page 63

Controlling the rest of your system 11 8 Repeat steps 5-7 to program a sequence of up to five commands. 9 When you're finished, use / to select EDITEXIT from the menu and press ENTER. You will return to the remote control SETUP menu. Select * EXIT * again to exit. Using multi operations You can start multi operations with the receiver switched on, or in standby. AUDIO SUBTITLE HDD DISP CH PHOTO THX STANDARD ADV.SURR DVD CH STEREO/ F.S.SURR MULTI OPE AUTOSURR ACOUSTIC EQ SIGNAL SEL SHIFT EFFECT/CHSEL LEVEL RECEIVER 1 Press MULTI OPE. MULTI OP flashes in the display. 2 Press an input source button that has been set up with a multi operation. The receiver switches on (if it was in standby) and the programmed multi operation is performed automatically. Using System off RECEIVER INPUT SELECT SYSTEM OFF SOURCE AUDIO DISP THX SUBTITLE HDD CH PHOTO STANDARD ADV.SURR DVD CH STEREO/ F.S.SURR MULTI OPE AUTOSURR ACOUSTIC EQ SIGNAL SEL SHIFT EFFECT/CHSEL LEVEL XM RADIO DVD SIRIUS TV DVR 2 DVR 1 TV CTRL RECEIVER 1 Press MULTI OPE. MULTI OP flashes in the display. 2 Press  SOURCE. The command sequence you programmed will run, then all Pioneer components will switch off1, followed by this receiver. Controls for TVs This remote control can control components after entering the proper codes or teaching the receiver the commands (see Setting the remote to control other components on page 61 for more on this). Use the input source buttons to select the component. • The TV CONTROL buttons on the remote control are dedicated to control the TV assigned to the TV CTRL button. If you have two TVs, assign the main TV to the TV CTRL button. Button(s) Function Components TV Press to switch the component assigned to the TV CONT button on or off. Cable TV/Satellite TV/TV/DTV INPUT SELECT Switches the TV input. (Not possible with all models.) Cable TV/Satellite TV/TV/DTV TV CH +/- Selects channels. Cable TV/Satellite TV/TV/DTV TV VOL +/- Adjust the TV volume. Cable TV/Satellite TV/TV/DTV SOURCE Switches the DTV on or off. DTV Switches the TV or CATV between Cable TV/Satellite standby and on. TV/TV  Switches the DTV on or off. DTV  Press to get information on DTV DTV programs.  Use to choose the BLUE DTV commands on a DTV menu.  Use to choose the YELLOW DTV commands on a DTV menu.  Use to choose the GREEN DTV commands on a DTV menu.  Use to choose the RED DTV commands on a DTV menu. AUDIO / DISP Use to switch DTV audio tracks. DTV SUBTITLE Use to return to the previously selected channel. Cable TV/Satellite TV/TV/DTV GUIDE Use as the GUIDE button for navigating. Cable TV/Satellite TV/TV/DTV ANT Use to select the VHF/UHF antennas or Cable TV. Cable TV/TV RETURN Use to select RETURN or EXIT. DTV Number buttons Use to select a specific TV channel. Cable TV/Satellite TV/TV/DTV +10 button Use to add a decimal point when DTV selecting a specific TV channel. ENTER/ DISC Use to enter a channel. Cable TV/Satellite TV/TV/DTV MENU Select different menus from the DTV DTV functions. Select the menu screen. Press to select or adjust and & ENTER navigate items on the menu screen. Cable TV/Satellite TV/TV Cable TV/Satellite TV/TV/DTV Note 1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent. 63 En