Pioneer VSX-LX305 Elite 9.2-Channel Network AV Receiver Instruction Manual Eng - Page 184

General Specifications Appendix Amplifier Section Rated Output Power Maximum Effective Output Power THD+N (Total Harmonic Distortion + Noise) Input Sensitivity and Impedance Rated RCA Output Level and Impedance Phono Maximum Input Signal Voltage Frequency Response Tone Control Characteristics Signal to Noise Ratio Speaker Impedance Headphone Rated Output Supported impedance of Headphones Headphones Frequency Response North American models European models Australian and Asian models With 8 ohm loads, both channels driven, from 20 Hz - 20 kHz; rated 100 watts per channel minimum RMS power, with no more than 0.08 % total harmonic distortion from 250 milliwatts to rated output. (FTC) 9 ch × 170 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD (IEC) 225 W at 6 ohms, 1 kHz, 1 ch driven 185 W at 6 ohms, 1 kHz, 1 ch driven 9 ch × 185 W at 6 ohms, 1 kHz, 1 ch of 10% THD of 10% THD (JEITA) driven of 10% THD (JEITA) 0.08% (20 Hz - 20,000 Hz, Rated output power) 200 mV/47 kΩ (LINE(RCA)), 3.5 mV/47 kΩ (PHONO MM) PREOUT (SUBWOOFER) : 1 V/470 Ω ZONE B LINEOUT, ZONE 2 PRE/LINEOUT : 200 mV/1 V/2.2 kΩ 70 mV (MM 1 kHz 0.5%) 10 Hz - 100 kHz/+1 dB, -3 dB (Direct/Pure Direct) MAIN : ±10 dB, 20 Hz (BASS), ±10 dB, 20 kHz (TREBLE) ZONE 2 : ±10 dB, 100 Hz (BASS), ±10 dB, 10 kHz (TREBLE) 106 dB (IHF-A, LINE IN, SP OUT), 80 dB (IHF-A, PHONO IN, SP OUT) 4 Ω - 16 Ω 85 mW + 85 mW (32 Ω, 1 kHz, 10% THD) 8 Ω - 600 Ω 10 Hz - 100 kHz 184