Polaroid EX53U User Manual - Page 28
Changing the settings for the projection, Changing the password, Restoring the default settings - xga projector
UPC - 082400027092
View all Polaroid EX53U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
How to use the administration screen (continued) Glossary TCP/IP IP Address DHCP Subnet Mask Gateway WEP SSID Transmission Control Protocol/Internet Protocol (TCP/IP) is the standard protocol used for networking. Protocol is a set of technical rules for the transmission of information between computers. IP Address is the numbered address to identify a server for networking. Internet Protocol (IP) is the protocol to transmit data over the Internet, and the IP Address, which consists of exactly same numbers as the other address in one network, is not available. Dynamic Host Configuration Protocol (DHCP) is the protocol dynamically allocating IP addresses to computers on a local area network. The computer with DHCP server can assign IP address to each computer on a local area network automatically. Subnet is the separated part of network, and subnet mask is a number that defines a range of IP addresses that can be used in the network. Gateway is either hardware or software that acts as a bridge between two networks. Gateway is a system for transmitting data across networks that are incompatible and use different protocols. Wired Equivalent Privacy (WEP) is a security protocol that adds security by encrypting data. The encryption key enables only the authorized systems on the network to recognize the data. Service Set ID (SSID) is the identifier for wireless local area networks, which identifies the access points necessary for transmitting. Some wireless local area network card uses [ESSID (Extended Service Set Identifier)] or network name as SSID. Changing the settings for the projection You can change the settings for the number of colors and the login code. 1. Click "Projection Setup". • You can change the following settings. Settings Contents Resolution The resolution of this projector is fixed at XGA. Color Depth You can specify the number of colors for the projected images. You can select "Normal (16 bit) (65,536 colors) or "High (32 bit)" (16,777,216 colors). Screen Refresh Rate The rate of this projector is fixed at 75 Hz. Login Code You can specify the login code to connect to the projector wirelessly. • Disable: You can connect to the projector wire- lessly without entering the login code. • Random: The login code is changed randomly each time the projector starts up. (Default) • Use the following code: Specify the login code. The login code is a four-digit number. 3. Check the displayed settings, then click the [OK] button. 4. Reboot the system. • The specified settings can be applied. • It takes approximately one minute to reboot the system. Changing the password You can change the passwords for the user (trainer) and administrator (admin). 1. Click "Change Passwords". 2. Enter a new password in "Conference Control" or "Admin", and then click each [Apply] button. 2. Change the settings, then click the [Apply] button. Restoring the default settings You can restore the default settings. 1. Click "Reset to Default". EN-28 2. Click the [Apply] button. 3. Check the displayed settings, then click the [OK] button. 4. Reboot the system. • The default settings can be restored. • It takes approximately one minute to reboot the system.