Poulan 1992-06 User Manual - Page 7

ASSEMBLY A. GETTING READY 1. READ YOUR OPERATOR'S MANUAL CAREFULLY YourOperator's Manual has been developed to help you prepare your saw for use and to understand its safe operation. It is important that you read your manual completely to become familiar with the unit before you begin assembly or attempt operation. Your POULAN PRO dealer is available to show you how to operate your saw Be sure to ask for his assistance. 2. HAVE THE FOLLOWING AVAILABLE: a. Protective gloves. b. Approved, marked fuel container. c. One gallon regular unleaded gasoline. d. 2 cycle, air-cooled engine oil (See the "Fueling Your Engine" section). e. Bar and Chain Oil (See the "Bar and Chain Oil" section). Scrench. B. ATTACHING THE SPUR (Optional) The spur is a special piece of equipment designed to assist the cutting operation. When assembled to saw, the spur will dig into tree or log and: • relieve contact pressure adding ease to the sawing operation. • allow the saw to be more easily rotated or pivoted into the cut. To Install: 1. Remove the bar clamp nuts, bar clamp, and plastic spacer. Figure 6 . Discard plastic spacer. NOTE; Be sure to remove the plastic spacer on the bar stud (between bar clamp and crankcase). Z Remove the isolator bracket screw. Figure 7 . 3. Remove and discard the spacer under the isolator bracket. Figure 7 4. Position the spur over the two holes in the shroud. Figure 6 . Make sure the bottom screw hole tab on the spur is positioned between the shroud and the isolator bracket (where the spacer was removed). 5. Insert the two spur screws and tighten evenly and securely. Bar Clamp Figure 6 Isolator Bracket aO k Clamp Nuts i\ F Isolator r Bracket O '1.4v3 s, Screw Spacer Figure 7 NOTES