Poulan HDF825 User Manual - Page 5

ASSEMBLY UNPACK CARTON & INSTALL HANDLE (See Fig. 2) CAUTION: Be careful of exposed staples when handling or disposing of cartoning material. IMPORTANT: WHEN UNPACKING AND ASSEMBLING TILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLE(S). • Cut cable ties securing handles. • Slowly lift handle assembly up, route cable(s) as shown and align handle holes with handle panel hole and slot. • Loosely assemble hardware as shown. Be sure the shorter (1" long) hex bolt is assembled in lower hole of handle. Repeat for opposite side. Tighten all hardware securely. • Cut cable ties securing tiller to skid and remove tiller from skid. • Remove screws securing depth stake to skid and discard the screws. LOCK NUT WASHER TILLER HANDLE HANDLE PANEL handles_38 FLAT WASHER HEX BOLT 5/16-18X1-1/4" HEX BOLT 5/16-18X1" 02051 CABLE(S) TILLER HANDLES HANDLE PANEL BOLTS INSTALL DEPTH STAKE ASSEMBLY (See Fig. 3) • Loosen nut "A". • Insert stake support between engine bracket halves with stake spring down. • Bolt stake support to engine brackets with bolts, lock washers and nuts. Tighten securely. Tighten nut "A". • Depth stake must move freely. If it does not, loosen support bolt. depth_stake_4 ENGINE BRACKET HALVES NUT "A" DEPTH STAKE DEPTH STAKE SUPPORT HEX BOLTS, LOCK WASHERS, AND HEX NUTS FIG. 3 SUPPORT BOLT STAKE SPRING HANDLE HEIGHT • Handle height may be adjusted to better suit operator. (See "HANDLE HEIGHT" in the Service and Adjustments section of this manual). TILLING WIDTH • Tilling width may be adjusted to better handle your tilling conditions (See "TINE ARRANGEMENT" in the Service and Adjustments section of this manual). TINE OPERATION • Check tine operation before first use. (See "TINE OPERATION CHECK" in the Service and Adjustments section of this manual). FIG. 2 5