Poulan PP1644JA User Manual - Page 18

Service, Adjustments

Page 18 highlights

SERVICE AND ADJUSTMENTS CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift lever in neutral (N) position. • Place attachment clutch in "DISENGAGED" position. • Turn ignition key "OFF" and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TRACTOR TO REMOVE MOWER (See Fig. 21) • Place attachment clutch in "DISENGAGED" position. • Turn height adjustment knob to lowest setting. • Lower mower to its lowest position. • Remove retainer spring holding anti-swaybar to chas- sis bracket and disengage anti-swaybar from bracket. • Remove retainer springs from suspension arms at deck and disengage arms from deck. • Raise attachment lift to its highest position. • Remove two retainer springs from each front link and remove links. • Slide mower forward and remove belt from electric clutch pulley. • Slide mower out from under right side of tractor. IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS. TO INSTALL MOWER Follow procedure described in "INSTALL MOWER AND DRIVE BELT" in the Assembly section of this manual. TO LEVEL MOWER HOUSING Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PRODUCT SPECIFICATIONS" on page 3 of this manual). If tires are over or underinflated, you will not properly adjust your mower. SIDE-TO-SIDE ADJUSTMENT (See Figs. 21 and 22) • Raise mower to its highest position. • Measure height from bottom of deck curl to ground level at front corners of mower. Distance "A" should be the same. • If distance "A" needs to be changed, make adjustment on one side of mower only. • Raise one side of mower by tightening lift link adjustment nut on that side. • Lower one side of mower by loosening lift link adjustment nut on that side. NOTE: Each half turn of adjustment nut will change deck level about 3/16". • Recheck level after adjusting. BOTTOM OF CURL o• o BOTTOM OF CURL SUSPENSION ARMS ADJUSTMENT NUTS LIFT LINKS FRONT SUSPENSION BRACKET CHASSIS BRACKET FRONT MOWER I BRACKET (11 -GROUND LINE - FIG. 22 ELECTRIC CLUTCH .(r PULLEY L, RETAINER SPRING \ ANTI-SWAY BAR RETAINER SPRINGS FIG„ 21 FRONT LINKS FRONT SUSPENSION BRACKET RETAINER SPRINGS FRONT MOWER BRACKET 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

ARMS
SERVICE
AND
ADJUSTMENTS
CAUTION:
BEFORE
PERFORMING
ANY
SERVICE
OR
ADJUSTMENTS:
Depress
clutch/brake
pedal
fully
and
set
parking
brake.
Place
gearshift
lever
in
neutral
(N)
position.
Place
attachment
clutch
in
"DISENGAGED"
position.
Turn
ignition
key
"OFF"
and
remove
key.
Make
sure
the
blades
and
all
moving
parts
have
completely
stopped.
Disconnect
spark
plug
wire
from
spark
plug
and
place
wire
where
it
cannot
come
in
contact
with
plug.
TRACTOR
TO
REMOVE
MOWER
(See
Fig.
21)
Place
attachment
clutch
in
"DISENGAGED"
position.
Turn
height
adjustment
knob
to
lowest
setting.
Lower
mower
to
its
lowest
position.
Remove
retainer
spring
holding
anti-swaybar
to
chas-
sis
bracket
and
disengage
anti-swaybar
from
bracket.
Remove
retainer
springs
from
suspension
arms
at
deck
and
disengage
arms
from
deck.
Raise
attachment
lift
to
its
highest
position.
Remove
two
retainer
springs
from
each
front
link
and
remove
links.
Slide
mower
forward
and
remove
belt
from
electric
clutch
pulley.
Slide
mower
out
from
under
right
side
of
tractor.
IMPORTANT:
IF
AN
ATTACHMENT
OTHER
THAN
THE
MOWER
DECK
IS
TO
BE
MOUNTED
ON
THE
TRACTOR,
REMOVE
THE
FRONT
LINKS.
TO
INSTALL
MOWER
Follow
procedure
described
in
"INSTALL
MOWER
AND
DRIVE
BELT"
in
the
Assembly
section
of
this
manual.
ADJUSTMENT
SUSPENSION
NUTS
LIFT
LINKS
CHASSIS
BRACKET
RETAINER
SPRING
ANTI
-SWAY
BAR
RETAINER
SPRINGS
FRONT
SUSPENSION
BRACKET
FRONT
MOWER
I
BRACKET
\
L,
TO
LEVEL
MOWER
HOUSING
Adjust
the
mower
while
tractor
is
parked
on
level
ground
or
driveway.
Make
sure
tires
are
properly
inflated
(See
"PRODUCT
SPECIFICATIONS"
on
page
3
of
this
manual).
If
tires
are
over
or
underinflated,
you
will
not
properly
adjust
your
mower.
SIDE
-TO
-SIDE
ADJUSTMENT
(See
Figs.
21
and
22)
Raise
mower
to
its
highest
position.
Measure
height
from
bottom
of
deck
curl
to
ground
level
at
front
corners
of
mower.
Distance
"A"
should
be
the
same.
If
distance
"A"
needs
to
be
changed,
make
adjustment
on
one
side
of
mower
only.
Raise
one
side
of
mower
by
tightening
lift
link
adjust-
ment
nut
on
that
side.
Lower
one
side
of
mower
by
loosening
lift
link
adjust-
ment
nut
on
that
side.
NOTE:
Each
half
turn
of
adjustment
nut
will
change
deck
level
about
3/16".
Recheck
level
after
adjusting.
BOTTOM
OF
CURL
o
o
-GROUND
LINE
-
BOTTOM
OF
CURL
(11
FRONT
LINKS
.(
r
RETAINER
SPRINGS
FIG.
22
ELECTRIC
CLUTCH
PULLEY
FRONT
SUSPENSION
BRACKET
FRONT
MOWER
BRACKET
FIG„
21
18