Poulan PP1644JA User Manual - Page 22

protection

Page 22 highlights

SERVICE AND ADJUSTMENTS TO ADJUST STEERING WHEEL ALIGNMENT If steering wheel crossbars are not horizontal (left to right) when wheels are positionedstraightforward, remove steering wheel and reassemble per instructions in the Assembly section of this manual. FRONT WHEEL TOE-IN/CAMBER The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center. TO REMOVE WHEEL.FOR REPAIRS (See Fig. 32) • Block up axle securely. • Remove wheel cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose). • Repair tire and reassemble. • On rear wheels only: align grooves in rear wheel hub and axle. Insert square key. • Replace washers and snap retaining ring securely in axle groove. • Replace wheel cover. WASHERS RETAINING RING e)* TO START ENGINE WITH A WEAK BATTERY (See Fig. 33) CAUTION: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries. If your battery is too weak to start the engine, it should be recharged. If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES. TO ATTACH JUMPER CABLES • Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis. • Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery. • Connect the other end of the BLACK cable to a good CHASSIS GROUND, away from fuel tank and battery. TO REMOVE CABLES, REVERSE ORDER • BLACK cable first from chassis and then from the fully charged battery. • RED cable last from both batteries. El "POSITIVE" (+) "NEGATIVE" (-) WHEEL COVER SQUARE KEY (REARWHEELONLY) FIG. 32 L.H. PANEL BOLT Pe 0 FIG. 33 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

SERVICE
AND
ADJUSTMENTS
TO
ADJUST
STEERING
WHEEL
ALIGNMENT
If
steering
wheel
crossbars
are
not
horizontal
(left
to
right)
when
wheels
are
positionedstraightforward,
remove
steer-
ing
wheel
and
reassemble
per
instructions
in
the
Assembly
section
of
this
manual.
FRONT
WHEEL
TOE-IN/CAMBER
The
front
wheel
toe
-in
and
camber
are
not
adjustable
on
your
tractor.
If
damage
has
occurred
to
affect
the
front
wheel
toe
-in
or
camber,
contact
your
nearest
authorized
service
center.
TO
START
ENGINE
WITH
A
WEAK
BATTERY
(See
Fig.
33)
CAUTION:
Lead
-acid
batteries
gener-
ate
explosive
gases.
Keep
sparks,
flame
and
smoking
materials
away
from
bat-
teries.
Always
wear
eye
protection
when
around
batteries.
If
your
battery
is
too
weak
to
start
the
engine,
it
should
be
recharged.
If
"jumper
cables"
are
used for
emergency
starting,
follow
this
procedure:
TO
REMOVE
WHEEL
.
FOR
REPAIRS
(See
Fig.
32)
IMPORTANT:
YOUR
TRACTOR
IS
EQUIPPED
WITH
A
12
VOLT
NEGATIVE
GROUNDED
SYSTEM.
THE
OTHER
VEHICLE
MUST
ALSO
BE
A
12
VOLT
NEGATIVE
Block
up
axle
securely.
GROUNDED
SYSTEM.
DO
NOT
USE
YOUR
TRACTOR
Remove
wheel
cover,
retaining
ring
and
washers
to
BATTERY
TO
START
OTHER
VEHICLES.
allow
wheel
removal
(rear
wheel
contains
a
square
key
TO
ATTACH
JUMPER
CABLES
-
-
Do
not
lose).
Connect
each
end
of
the
RED
cable
to
the
POSITIVE
Repair
tire
and
reassemble.
(+)
terminal
of
each
battery,
taking
care
not
to
short
against
chassis.
On
rear
wheels
only:
align
grooves
in
rear
wheel
hub
and
axle.
Insert
square
key.
Connect
one
end
of
the
BLACK
cable
to
the
NEGA-
Replace
washers
and
snap
retaining
ring
securely
in
TIVE
(-)
terminal
of
fully
charged
battery.
axle
groove.
Connect
the
other
end
of
the
BLACK
cable
to
a
good
Replace
wheel
cover.
CHASSIS
GROUND,
away
from
fuel
tank
and
battery.
TO
REMOVE
CABLES,
REVERSE
ORDER
-
WASHERS
RETAINING
RING
e)*
SQUARE
KEY
WHEEL
COVER
(REARWHEELONLY)
FIG.
32
BLACK
cable
first
from
chassis
and
then
from
the
fully
charged
battery.
RED
cable
last
from
both
batteries.
El
"POSITIVE"
(+)
"NEGATIVE"
(-)
0
L.H.
PANEL
BOLT
Pe
FIG.
33
22