Poulan PP16H44A User Manual - Page 19

SERVICE AND ADJUSTMENTS a CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress clutch/brake pedal fully and set parking brake. • Place motion control lever in "NEUTRAL' position. • Place attachment clutch in "DISENGAGED" position. • Turn ignition key "OFF" and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. 3ACTOR REMOVE MOWER (See Fig. 24) wer will be easier to remove from the right side of unit. Remove mower drive belt from electric clutch pulley only (See "TO REPLACE MOWER DRIVE BELT" through step removing belt from electric clutch pulley). Pull retainer springs cut of rear suspension trunnions. Remove rear suspension trunnions from lift brackets. Pull retainer springs from front hinge pins. Remove hinge pins attaching parallel link to mower and front axle. Raise lift lever to raise suspension arms. Slide mower out from under tractor. 'ORTANT: IFANATTACHMENTOTHER THANTHEMOWER IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE AND R.H. SUSPENSION ARMS AND THE FRONT SPENSION BRACKET. \\ JSPENSIO RMS RETAINER SPRINGS ELECTRIC CLUTCH PULLEY ?AR JSPENSION 1UNNION 3 RETAINER SPRING N. LONG HINGE PIN SIDE-TO-SIDE ADJUSTMENT (See Figs. 25 and 26) • Raise attachment lift lever to its highest position. • Measure height from bottom deck curl to ground level at front corners of mower. Distance "A" should be the same. BOTTOM OF CURL ARIP6046 0• 0 BOTTOM OF CURL JR. GROUND LINE FIG. 25 • If distance "A" needs to be changed, snap out access hole cover on left side of tractor above footrest. • To raise left side of mower, loosen nut "B" and tighten nut "C". • To lower left side of mower, loosen nut "C" and tighten nut "B". • When distance "A" is equal, securely tighten nuts "B" and "C". SIDE TO SIDE ADJUSTMENT TRUNNION NUT "C" FIG. 24 INSTALL MOWER e "INSTALL MOWER" in the Assembly section of this nual. ) LEVEL MOWER HOUSING just the mower while tractor is parked on level ground or ,/eway. Make sure tires are properly inflated (See RODUCT SPECIFICATIONS" on page 3). If tires are or underinflated, you will not properly adjust your iwer. 19 FIG. 26 Replace access hole cover. NUT "B"