Poulan XC1182B User Manual - Page 24
Adjust, Throttle, Control, Cable, Carburetor
![]() |
View all Poulan XC1182B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
SERVICE AND ADJUSTMENTS ENGINE TO ADJUST THROTTLE CONTROL CABLE (See FIG. 38) The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows: • With engine not running, move throttle control lever to "FAST" position. • Check that throttle lever is against stop. If it is not, loosen cable clamp screw and pull cable back until throttle lever is against stop. Tighten cable clamp screw securely. CLAMP SCREW THROTTLE LEVER SHOWN IN HIGH SPEED POSITION THROTTLE LEVER SHOWN IN LOW SPEED POSITION TO ADJUST CARBURETOR The carburetor has been preset at the factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjust- ment, see engine manual packed with your unit. IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVER- SPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER, WHICH HAS PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS. INNER WIRE HIGH SPEED STOP FIG. 38
![](/manual_guide/products/poulan-xc1182b-user-manual-f36cfed/24.png)