Poulan XC1182B User Manual - Page 9

ASSEMBLY INSTALL MOWER (See FIGS. 5, 6, 7 & 8) Your unit has been shipped with the mower parallel link included in the parts carton. Install mower parallel link on unit using short hinge pin and retainer spring. NOTE: Smaller end of parallel link mounts to tractor. Use the shortest hinge pin for mounting. HEIGHT ADJUSTMENT KNOB UFT LEVER PLUNGER RETAINER SPRING • 0 0 0 0• SHORT HINGE PIN • • • MOWER PARALLEL UNK FIG. 5 • Raise attachment lift lever to its highest position. • Remove banding from suspension arms. • Slide mower under tractor with discharge guard to right side of tractor. • Attach front of mower to parallel link with long hinge pin. Secure hinge pin with retainer spring. • Turn height adjustment knob to its lowest setting. • Lower attachment lift lever to lower suspension arms. Re- move retainer springs from lift trunnions. • Slide trunnions through upper lift bracket holes and se- cure with retainer springs. • Pull L.N. idler pulley toward the right hand side of tractor and roll belt over electric clutch pulley. SUSPENSION ARMS LIFT TRUNNION RETAINER SPRING ELECTRIC CLUTCH PULLEY FIG. 7 ATTACHMENT LIFT LEVER RAISE HEIGHT ADJUSTMENT KNOB LOWER FIG. 8 CHECK DECK LEVELNESS For best cutting results, mower housing should be properly leveled. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual. CHECK FOR PROPER POSITION OF ALL BELTS See the figures that are shown for replacing motion, mower drive, and mower blade drive belts in the Service and Adjustments section of this manual. Verify that the belts are routed correctly. CHECK BRAKE SYSTEM After you learn how to operate your tractor, check to see that the brake is properly adjusted. See "TO ADJUST BRAKE" in the Service and Adjustments section of this manual. LIFT BRACKET RETAINER SPRING FIG. 6 LONG HINGE PIN NOTE: Mower drive belt installation decal located on mower housing. • Raise attachment lift lever to raise mower. • Turn height adjustment knob clockwise to the middle of its travel.