ProForm 100 Zlx Bike Uk Manual - Page 19
Loosen the M6 x 20mm Hex Screw 60. Then, tighten
View all ProForm 100 Zlx Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. To adjust the drive belt, you must remove the seat post, the adjustment knob, the top shield, the right pedal, and the right shield (see the instructions below). To remove the Seat Post (5), loosen the Seat Post Knob (11) a few turns, pull the Seat Post Knob outward, and remove the Seat Post. Then, using an adjustable wrench, remove the Seat Post Knob. Remove all the screws from the left and right shields; there are two sizes of screws in the shields-note which size of screw you remove from each hole. Then, gently pull the right shield away from the frame. Loosen the M6 x 20mm Hex Screw (60). Then, tighten the M10 x 50mm Hex Screw (33) until the Drive Belt (23) is tight. 23 5 11 9 26 60 33 When the Drive Belt (23) is tight, tighten the M6 x 20mm Hex Screw (60). Then, reattach the left and right shields, the right pedal, the top shield, the adjustment knob, and the seat post. Using a flat screwdriver, release the tabs along the bottom edge of the Top Shield (9) and slide the Top Shield upward. Then, using an adjustable wrench, turn the Right Pedal (26) counterclockwise and remove it. 19