ProForm 280 Zlx Bike Uk Manual - Page 17

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. To clean the exercise cycle, use a damp cloth and a small amount of mild detergent. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. Locate the Reed Switch (39). Turn the Left Crank Arm (66) until a Magnet (38) is aligned with the Reed Switch. Loosen, but do not remove, the M5 x 15mm Screw (47). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Turn the Left Crank Arm for a moment. Repeat until the console displays correct feedback. CONSOLE TROUBLESHOOTING If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, see assembly step 5 on page 8. If the handgrip pulse sensor does not function properly, see step 5 on page 15. 38 HOW TO ADJUST THE REED SWITCH 39 If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, the left pedal and the left shield must be 47 66 removed. Using an adjustable wrench, turn the left pedal clockwise and remove it. Next, remove all of the screws from both shields; there are two sizes of screws in the shields-note which size of screw you remove from each hole. Then, carefully remove the left shield. When the Reed Switch is correctly adjusted, reattach the shields and the left pedal. 17