ProForm 305 Cst Instruction Manual - Page 7

ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • To identify small parts, see page 6. • Assembly requires the following tools: the included hex key one Phillips screwdriver To avoid damaging parts, do not use power tools. 1. To register your product and activate your warranty in the UK, go to iconsupport.eu. If 1 you do not have internet access, call Customer Service (see the front cover of this manual).  To register your product and activate your warranty in Australia, email or post the following information to the email address or postal address on the front cover of this manual. • your receipt (make sure to keep a copy) • your name, address, and telephone number • the model number, serial number, and name of your product (see the front cover of this manual) 2. Make sure that the power cord is unplugged. 2 Remove and discard the two screws (A) and the shipping bracket (B) on the right side of the Base (74). Then, remove and discard the screws and the shipping bracket (not shown) on the left side of the Base. Next, remove the tie (C) securing the Upright Wire (63). Then, press a Base Cap (70) into each side of the Base (74). B 74 A C 63 70 7