ProForm 405 Spx Instruction Manual - Page 5

ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you inish all assembly steps. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • In addition to the included tool(s), assembly requires the following tool(s): one adjustable wrench one rubber mallet Assembly may be easier if you have a set of wrenches. To avoid damaging parts, do not use power tools. 1. Go to www.iconsupport.eu on your computer and register your product. 1 • documents your ownership • activates your warranty • ensures priority customer support if assistance is ever needed  Note: If you do not have internet access, call Customer Care (see the front cover of this manual) and register your product. 2. If there are shipping tubes (not shown) attached to the front and rear of the Frame (1), remove 2 and discard the shipping tubes and the hardware attaching them. O rient the Front Stabilizer (4) as shown. Attach the Front Stabilizer (4) to the Frame (1) with two M8 x 55mm Carriage Bolts (9), two M8 Washers (3), and two M8 Flange Nuts (2). 2 3 1 4 9 6