ProForm 650 Elliptical Uk Manual - Page 7

4. While another person holds the Upright (2) in the position shown, connect the Upper Wire Harness (86) to the Extension Wire Harness (95). Next, insert the Upright (2) into the Mast (15); make sure that the Upright is oriented as shown. Attach the Upright with two M8 x 70mm Button Bolts (67), two M8 Split Washers (83), and two M8 Nylon Locknuts (46). Make sure that the Wire Harnesses (86, 95) do not get pinched and damaged during this step. Do not tighten the Button Bolts yet. Attach the Water Bottle Holder (72) to the Upright (2) with two M4 x 22mm Screws (76). 4 2 86 95 46 Hexagonal Holes Make sure that the wire harnesses do not get pinched and damaged during this step. 72 76 83 67 83 15 5. The Console (5) requires four 1.5V "D" batteries; alka- 5 line batteries are recommended. Loosen the indicated screw from the battery drawer, and pull the battery drawer open. Insert four batteries into the battery drawer; make sure that the batteries are oriented as shown by the markings inside of the battery drawer. Then, close the battery drawer and tighten the screw. 5 Batteries 6. While another person holds the Console (5) near the Upright (2), connect the wire harness on the Console to the Upper Wire Harness (86). Insert the excess wire harness down into the Upright. Next, attach the Console to the Upright with four M4 x 16mm Screws (66). Be careful to avoid pinching the wire harnesses. Screw 6 Battery Drawer Wire Harness 5 86 Make sure the wire harnesses do 2 not get pinched and damaged 66 during this step. 7