ProForm Performance 1250 Treadmill Uk Manual - Page 7
Assembly
View all ProForm Performance 1250 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish assembly. • The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • To identify small parts, see page 6. • Assembly requires the following tools: the included hex keys one adjustable wrench one Phillips screwdriver scissors To avoid damaging parts, do not use power tools for assembly. 1. Make sure that the power cord is unplugged. 1 Place a piece of cardboard below the rear of the Frame (56) to protect the floor or carpet. Attach the Left Wheel Cap (96) to the Base (94) with two #8 x 3/4" Screws (2). Attach the Right Wheel Cap (not shown) to the right side of the Base (94) in the same way. 2. Pull the Upright Wire (81) and the Base Ground Wire (110) through the indicated hole in the 2 Base (94). Attach the Base Ground Wire (110) to the Base (94) with a #8 x 1/2" Ground Screw (10). Press the Grommet (77) into the square hole in the Base (94). 56 94 2 96 Cardboard 77 Hole 81 110 10 94 7