ProForm Performance 300i Uk Manual - Page 11

This will push a, spacer H out of the Storage Latch; discard, the spacer., Do not overtighten

Get ProForm Performance 300i PDF manuals and user guides View all ProForm Performance 300i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

10. Remove the M8 Nut (39) and the M8 x 35mm Bolt (7) from the bracket on the Base (36). 10 Next, orient the Storage Latch (42) as shown. Attach the lower end of the Storage Latch (42) to the bracket on the Base (36) with the M8 x 35mm Bolt (7) and the M8 Nut (39). Then, raise the Storage Latch (42) to a vertical position, and remove the tie. Tie 42 39 36 7 11. Remove the M8 Nut (39) and the M8 x 52mm Bolt (28) from the bracket on the Latch Crossbar (34). Align the upper end of the Storage Latch (42) with the bracket on the Latch Crossbar (34), and insert the M8 x 52mm Bolt (28) through the bracket and the Storage Latch. This will push a spacer (H) out of the Storage Latch; discard the spacer. Next, tighten the M8 Nut (39) onto the M8 x 52mm Bolt (28). Do not overtighten the Nut; the Storage Latch (42) must be able to pivot.  Then, lower the Frame (50) (see HOW TO LOWER THE TREADMILL FOR USE on page 21). 11 50 39 34 28 H 42 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
11
36
42
7
39
Tie
10
10.
Remove the M8 Nut (39) and the M8 x 35mm Bolt
(7) from the bracket on the Base (36).
Next, orient the Storage Latch (42) as shown.
Attach the lower end of the Storage Latch (42)
to the bracket on the Base (36) with the M8 x
35mm Bolt (7) and the M8 Nut (39).
Then, raise the Storage Latch (42) to a vertical
position, and remove the tie.
34
28
39
H
42
11
11. Remove the M8 Nut (39) and the M8 x 52mm Bolt
(28) from the bracket on the Latch Crossbar (34).
Align the upper end of the Storage Latch (42)
with the bracket on the Latch Crossbar (34),
and insert the M8 x 52mm Bolt (28) through the
bracket and the Storage Latch.
This will push a
spacer (H) out of the Storage Latch; discard
the spacer.
Next, tighten the M8 Nut (39) onto the M8 x
52mm Bolt (28).
Do not overtighten the Nut;
the Storage Latch (42) must be able to pivot.
Then, lower the Frame (50) (see HOW TO
LOWER THE TREADMILL FOR USE on page
21).
50