ProForm Performance 300i Uk Manual - Page 9

6. IMPORTANT: To avoid damaging the Pulse Crossbar (97), do not use power tools and do not overtighten the #10 x 3/4" Screws (80). Orient the Pulse Crossbar (97) as shown. Attach the Pulse Crossbar to the Left and Right Handrails (69, 86) with four #10 x 3/4" Screws (80) and four #10 Star Washers (83); start all four Screws, and then tighten them. Then, firmly tighten the two 3/8" x 2 3/4" Screws (1) and the two 5/16" x 3/4" Screws (4). 6 80 83 1 69 4 97 80 83 86 1 4 7. With the help of a second person, hold the console assembly (B) near the Right Handrail (86) (only one side is shown). Insert the Upright Wire (71) through the three looped Wire Ties (75) under the console assembly. Next, connect the ground wire (D) to the Console Ground Wire (98) on the Pulse Crossbar (97).  See the inset drawing. Connect the Upright Wire (71) to the console wire (E). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. 7 B 86 75 E 75 D 71 98 97 E 71 9