ProForm Performance 300i Uk Manual - Page 23
retighten the Tek Screw. Reattach the Motor Hood
View all ProForm Performance 300i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Remove the six indicated M4.2 x 19mm Screws (3) and the six Foot Rail Washers (25). Next, lower the Frame (50) (see HOW TO LOWER THE TREADMILL FOR USE on page 21). a 50 3 25 3 25 3 3 Locate the Reed Switch (100) and the Magnet (91) on the left side of the Pulley (46). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If necessary, loosen the M4.2 x 13mm Tek Screw (112), move the Reed Switch slightly, and then retighten the Tek Screw. Reattach the Motor Hood (not shown), and run the treadmill for a few minutes to check for a correct speed reading. Top View 1/8 in. 112 100 46 91 Remove the five indicated M4.2 x 19mm Washer Head Screws (9). Then, carefully remove the Motor Hood (56). 56 9 9 9 SYMPTOM: The incline of the treadmill does not change correctly a. Hold down the Stop button and the Speed increase button, insert the key into the console, and then release the Stop button and the Speed increase button. Next, press the Stop button and then press the Incline increase or decrease button. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system. If the incline system does not begin calibrating, press the Stop button again, and then press the Incline increase or decrease button again. When the incline system is calibrated, remove the key from the console. SYMPTOM: The walking belt slows when walked on a. If an extension cord is needed, use only a 3-conductor, 14-gauge (1 mm2) cord that is no longer than 5 ft. (1.5 m). 23