ProForm Sr30 English Manual - Page 11
Maintenance And Troubleshooting - battery replacement
View all ProForm Sr30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and properly tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. To clean the exercise cycle, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. PULSE SENSOR TROUBLESHOOTING For optimal performance of the pulse sensor, keep the metal contacts clean. The contacts can be cleaned with a soft cloth-never use alcohol, abrasives, or chemicals. Avoid moving your hands while using the pulse sensor. Excessive movement may interfere with heart rate readings. Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings. For the most accurate heart rate reading, hold the metal contacts for about 15 seconds. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, the left side shield must be removed. First, remove the five M4 x 25mm Screws (39) from the Right Side Shield (16). Next, remove the M4 x 12mm Screw (57) from the right side of the Side Shield Cover (17). 16 17 39 57 39 Using an adjustable wrench, turn the Left Pedal (20) clockwise and remove it. Next, remove the two M4 x 16mm Screws (40) from the Left Side Shield (15) and the M4 x 12mm Screw (57) from the Side Shield Cover (17). Lift off the Side Shield Cover and the Left Side Shield. 15 17 57 20 40 Next, locate the Reed Switch (46). Turn the left arm of the Crank (14) until the 40 Magnet (58) is 58 46 aligned with the Reed Switch. 14 Loosen, but do not remove, the indicated M4 x 16mm Screw (40). Slide the Reed Switch slightly closer to or away from the Magnet. Retighten the Screw. Turn the Crank Arm for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjust- ed, reattach the left side shield, the side shield cover, and the left pedal. BATTERY REPLACEMENT If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, refer to assembly step 8 on page 6 and remove the console from the upright. Next, refer to step 7 and insert three batteries into the console. Reattach the console to the upright. Be careful not to pinch the wires or the cable. 11