ProForm Sr30 English Manual - Page 6

5. Hold the Seat Frame (6) at an angle, and insert the tab 5 on the Seat Frame into the indicated slot in the Seat Carriage (4). Attach the Seat Frame to the Seat Carriage with two M10 x 66mm Button Bolts (47) and two M10 Split Washers (43). Tab Slot 6 4 43 43 47 6. Attach the Backrest (9) to the Seat Carriage (4) with two M6 x 16mm Screws (37), an M6 x 53mm Screw (30), and an M6 Flat Washer (38) as shown. 6 9 7. The Console (12) requires three "AA" batteries (not included); alkaline batteries are recommended. Insert 7 three batteries into the Console as shown. Make sure that the batteries are oriented as shown by the dia- gram inside the Console. 12 4 38 30 37 Batteries 8. Hold the Console (12) near the Upright (11). Insert the console cable and the console wire into the indicated hole and down through the Upright. Attach the ground wire to the Upright with an M4 x 16mm Screw (40). Insert the excess wire and cable into the Upright (11). Attach the Console (12) to the Upright with four M4 x 16mm Screws (40). Make sure that the wires and the cable are not pinched. 8 12 Ground Wire 40 40 Hole 11 Console Wire Console Cable 40 6